Allied Telesis AT-x510-28GTX Command Reference Manual page 804

R C
OUTING OMMANDS
SHOW IP ROUTE
•
•
Figure 23-1: Example output from the show ip route command
Codes: C - connected, S - static, R - RIP, B - BGP
O - OSPF, IA - OSPF inter area
N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
E1 - OSPF external type 1, E2 - OSPF external type 2
* - candidate default

O 10.10.37.0/24 [110/11] via 10.10.31.16, vlan2, 00:20:54
C 3.3.3.0/24 is directly connected, vlan1
C 10.10.31.0/24 is directly connected, vlan2
C 10.70.0.0/24 is directly connected, vlan4
O E2 14.5.1.0/24 [110/20] via 10.10.31.16, vlan2, 00:18:56
C 33.33.33.33/32 is directly connected, lo
Connected Route The connected route entry consists of:
This route entry denotes:
•
•
OSPF Route The OSPF route entry consists of:
This route entry denotes:
•
•
•
•
•
OSPF External The OSPF external route entry consists of:
Route
This route entry denotes that this route is the same as the other OSPF route
explained above; the main difference is that it is a Type 2 External OSPF route.
C613-50102-01 REV C
outgoing interface name
time since route entry was added
C 10.10.31.0/24 is directly connected, vlan2
Route entries for network 10.10.31.0/24 are derived from the IP address
of local interface vlan2.
These routes are marked as Connected routes (C) and always preferred
over routes for the same network learned from other routing protocols.
O 10.10.37.0/24 [110/11] via 10.10.31.16, vlan2, 00:20:54
This route in the network 10.10.37.0/24 was added by OSPF.
This route has an administrative distance of 110 and metric/cost of 11.
This route is reachable via next hop 10.10.31.16.
The outgoing local interface for this route is vlan2.
This route was added 20 minutes and 54 seconds ago.
O E2 14.5.1.0/24 [110/20] via 10.10.31.16, vlan2, 00:18:56
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
804