Vlan Classifier Rule Ipv4 - Allied Telesis AT-x510-28GTX Command Reference Manual

VLAN C
OMMANDS
4
VLAN CLASSIFIER RULE IPV

vlan classifier rule ipv4

Overview Use this command to create an IPv4 subnet-based VLAN classifier rule and map it
to a specific VLAN. Use the no variant of this command to delete the VLAN classifier
rule.
vlan classifier rule <1-256> ipv4 <ip-addr/prefix-length> vlan
Syntax
<1-4094>
no vlan classifier rule <1-256>
Mode Global Configuration
Usage If the source IP address matches the IP subnet specified in the VLAN classifier rule,
the received packets are mapped to the specified VLAN.
NOTE
packets. To ensure ARP traffic is classified into the correct subnet VLAN, you can use a
hardware based policy map that sends ARP packets to the CPU, which will then process
them appropriately. This means that if you use subnet-based VLANs, you should also
configure the following:
NOTE
using the service-policy input command:
awplus#
Example
awplus(config)#
Related show vlan classifier rule
Commands
vlan classifier activate
vlan classifier rule proto
C613-50102-01 REV C
Parameter
<1-256>
<ip-addr/prefix-length>
<1-4094>
: The subnet VLAN classifier only matches IPv4 packets. It does not match ARP
: The policy map should be applied to each port that uses a subnet based VLAN
configure terminal
vlan classifier rule 3 ipv4 3.3.3.3/8 vlan 5
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specify the VLAN Classifier Rule identifier.
Specify the IP address and prefix length.
Specify a VLAN ID to which an untagged packet is
mapped in the range <1-4094>.
534