Findme - Allied Telesis AT-x510-28GTX Command Reference Manual

S C M
YSTEM ONFIGURATION AND

FINDME

findme
Overview Use this command to physically locate a specific device from a group of similar
devices. Activating the command causes a selected number of port LEDs to
alternately flash green then amber (if that device has amber LEDs) at a rate of 1 Hz.
Use the no variant of this command to deactivate the Find Me feature prior to the
timeout expiring.
findme [interface <port-list>|member <stack-ID>] [timeout
Syntax
<duration>]
no findme
Default By default all port LEDs flash for 60 seconds.
Mode Privileged Exec
Usage Running the findme command causes the device's port LEDs to flash. An optional
timeout parameter specifies the flash behavior duration. Normal LED behavior is
restored automatically after either the default time, or a specified time has elapsed,
or a no findme command is used. You can specify which interface or interfaces are
flashed with the optional interface parameter.
You can specify a particular stack member with the optional member parameter.
All available interfaces are flashed by default.
NOTE
Example To activate the Find Me feature for the default duration (60 seconds) on all ports,
use the following command:
awplus#
To activate the Find Me feature for 120 seconds on all ports, use the following
command:
awplus#
C613-50102-01 REV C
C
ONITORING OMMANDS
Parameter
interface <port-list>
member <stack-ID>
timeout <duration>
: The interface and member parameters are mutually exclusive.
findme
findme timeout 120
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
The ports to flash. The port list can be:
• a switch port, e.g. port1.0.4
• a continuous range of ports separated by a hyphen,
e.g. port1.0.1-1.0.4
• a comma-separated list of ports and port ranges,
e.g. port1.0.1,port1.0.5-1.0.6.
Stack member number, from 1 to 8.
How long the LEDs flash, in seconds, in the range 5 to
3600 seconds.
235