Allied Telesis AT-x510-28GTX Command Reference Manual page 622

L A C
INK GGREGATION OMMANDS
-
CHANNEL GROUP
Examples To add device port1.0.6 to a newly created LACP channel group 2 use the
commands below:
awplus#
awplus(config)#
awplus(config-if)#
To remove device port1.0.6 from any created LACP channel groups use the
command below:
awplus#
awplus(config)#
awplus(config-if)#
To reference channel group 2 as an interface, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show etherchannel
Commands
show etherchannel detail
show etherchannel summary
show port etherchannel
C613-50102-01 REV C
configure terminal
interface port1.0.6
channel-group 2 mode active
configure terminal
interface port1.0.6
no channel-group
configure terminal
interface po2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
622