Allied Telesis AT-x510-28GTX Command Reference Manual page 304

P C C
LUGGABLES AND ABLING OMMANDS
SHOW SYSTEM PLUGGABLE DETAIL
•
NOTE
instead.
Example To display detailed information about the pluggable transceivers installed in a
particular port on the device, use a command like:
awplus#
To display detailed information about all the pluggable transceivers installed on
the device, use the command:
awplus#
Output Figure 8-4:
Table 10: Parameters in the output from the show system pluggable detail
C613-50102-01 REV C
Power Monitoring: Displays the received power measurement type, which
can be either OMA(Optical Module Amplitude) or Avg(Average Power)
measured in μW.
: For parameters that are not supported or not specified, a hyphen is displayed
show system pluggable port1.0.25 detail
show system pluggable detail
Example output from the show system pluggable detail
command for a specific port on a device
awplus#show system pluggable port1.0.25 detail
System Pluggable Information Detail

Port1.0.25
==========
Vendor Name:
Device Name:
Device Revision:
Device Type:
Serial Number:
Manufacturing Datecode:
SFP Laser Wavelength:
Link Length Supported
Single Mode Fiber :
OM1 (62.5um) Fiber:
OM2 (50um) Fiber
Diagnostic Calibration:
Power Monitoring:
FEC BER support:
command:
Parameter
Stack member
Port
Vendor Name
Device Name
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
AGILENT
HFCT-5710L
A
1000BASE-LX
0402142241184360
040214
-
10Km
550m
: 550m
Internal
Avg
-
Description
The stack member number.
Specifies the port the pluggable transceiver is installed in.
Specifies the vendor's name for the installed pluggable
transceiver.
Specifies the device name for the installed pluggable
transceiver.
304