Ripng For Ipv6 Commands; Introduction; Chapter 25: Ripng For Ipv6 Commands - Allied Telesis AT-x510-28GTX Command Reference Manual

25

Introduction

Overview This chapter contains RIPng commands. RIPng (Routing Information Protocol next
generation) is an extension of RIPv2 to support IPv6. RFC 2080 specifies RIPng. The
differences between RIPv2 and RIPng are:
•
•
•
For more information, see the
Command List •
•
•
•
•
•
•
•
•
•
•
•
•
•
•
C613-50102-01 REV C
RIPng does not support RIP updates authentication
RIPng does not allow the attachment of arbitrary tags to routes
RIPng requires the encoding of the next-hop for a set of routes
"aggregate-address (IPv6
"clear ipv6 rip route" on page 868
"debug ipv6 rip" on page 869
"default-information originate (IPv6
"default-metric (IPv6 RIPng)" on page 871
"distribute-list (IPv6 RIPng)" on page 872
"ipv6 rip metric-offset" on page 873
"ipv6 rip split-horizon" on page 875
"ipv6 router rip" on page 876
"neighbor (IPv6 RIPng)" on page 877
"offset-list (IPv6 RIPng)" on page 878
"passive-interface (IPv6
"recv-buffer-size (IPv6
"redistribute (IPv6 RIPng)" on page 881
"route (IPv6 RIPng)" on page 882
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
RIPng for IPv6
Commands
RIPng Feature Overview and Configuration
RIPng)" on page 867
RIPng)" on page 870
RIPng)" on page 879
RIPng)" on page 880
Guide.
865