Show System Fiber-Monitoring - Allied Telesis AT-x510-28GTX Command Reference Manual

P C C
LUGGABLES AND ABLING OMMANDS
-
SHOW SYSTEM FIBER MONITORING

show system fiber-monitoring

Overview Use this command to display settings and current status for Active Fiber
Monitoring.
show system fiber-monitoring
Syntax
Mode User Exec/Privileged Exec
Example To display configuration and status for active fiber monitoring on ports, use the
command:
awplus#
Output Figure 8-2:
C613-50102-01 REV C
show system fiber-monitoring
Example output from show system fiber-monitoring
awplus#show sys fiber-monitoring 
Fiber Monitoring Status
Reading units 0.0001mW

Stack member 1:

Interface port1.0.1
Status: enabled
Supported: Supported pluggable
Debugging: disabled
Interval: 2 seconds
Sensitivity: 1.00dB
Baseline type: average of last 35 values greater than 50
Status:
Baseline value:
Alarm threshold:
Alarm:
Last 12 Readings: 498 498 498 498 498 498 498 498 498 498 498 498 
Minimum reading: 486
Maximum reading: 498

Interface port1.0.2
Status: enabled
Supported: Supported pluggable
Debugging: disabled
Interval: 2 seconds
Sensitivity: 1.00dB
Baseline type: average of last 30 values greater than 50
Status:
Baseline value:
Alarm threshold:
Alarm:
Last 12 Readings: 0 0 0 0 0 0 0 0 0 0 0 0 
Minimum reading: 0
Maximum reading: 0
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
496
393
no
0
0
no
298