Allied Telesis AT-x510-28GTX Command Reference Manual page 305

P C C
LUGGABLES AND ABLING OMMANDS
SHOW SYSTEM PLUGGABLE DETAIL
Table 10: Parameters in the output from the show system pluggable detail
Related show system environment
Commands
show system pluggable
show system pluggable diagnostics
C613-50102-01 REV C
command: (cont.)
Parameter
Device Revision
Device Type
Serial Number
Manufacturing
Datecode
SFP Laser Wavelength
Single Mode Fiber
OM1 (62.5um) Fiber
OM2 (50um) Fiber
Diagnostic Calibration
Power Monitoring
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
Specifies the hardware revision code for the pluggable
transceiver. This may be useful for troubleshooting because
different devices may support different pluggable
transceiver revisions.
Specifies the device type for the installed pluggable
transceiver..
Specifies the serial number for the installed pluggable
transceiver.
Specifies the manufacturing datecode for the installed
pluggable transceiver. Checking the manufacturing
datecode with the vendor may be useful when
determining Laser Diode aging issues. For more
information, see "How To Troubleshoot Fiber and
Pluggable Issues" in the "Getting Started with AlliedWare
Plus" Feature Overview and Configuration
Specifies the laser wavelength of the installed pluggable
transceiver.
Specifies the link length supported by the pluggable
transceiver using single mode fiber.
Specifies the link length (in μm - micron) supported by the
pluggable transceiver using 62.5 micron multi-mode fiber.
Specifies the link length (in μm - micron) supported by the
pluggable transceiver using 50 micron multi-mode fiber.
Specifies whether the pluggable transceiver supports DDM
or DOM Internal or External Calibration:
Internal is displayed if the pluggable transceiver supports
DDM or DOM Internal Calibration.
External is displayed if the pluggable transceiver supports
DDM or DOM External Calibration.
- is displayed if neither Internal Calibration or External
Calibration is supported.
Displays the received power measurement type, which can
be either OMA (Optical Module Amplitude) or Avg
(Average Power) measured in μW.
Guide.
305