Ip Redirects - Allied Telesis AT-x510-28GTX Command Reference Manual

IP A P
DDRESSING AND ROTOCOL

IP REDIRECTS

ip redirects
Overview This command enables the device to send ICMP redirects on one or more
interfaces.
Use the no variant of this command to stop the device from sending ICMP redirects
on one or more interfaces.
Syntax ip redirects
no ip redirects
Default ICMP redirects are disabled by default.
Mode Interface Configuration for a VLAN interface.
Usage ICMP redirect messages are used to notify hosts that a better route is available to a
destination.
ICMP redirects are used when a packet is routed into the device on the same
interface that the packet is routed out of the device. ICMP redirects are only sent to
packet sources that are directly connected to the device.
Examples To enable the device to send ICMP redirects on interface vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
To stop the device from sending ICMP redirects on interface vlan2, use the
following commands:
awplus#
awplus(config)#
awplus(config-if)#
C613-50102-01 REV C
C
OMMANDS
configure terminal
interface vlan2
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
ip redirects
no ip redirects
715