Recv-Buffer-Size (Ipv6 Ripng) - Allied Telesis AT-x510-28GTX Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
- - (IP 6 RIP )
RECV BUFFER SIZE V NG

recv-buffer-size (IPv6 RIPng)

Overview Use this command to configure the RIPng UDP (User Datagram Protocol)
receive-buffer size. This should improve UDP reliability by avoiding UDP receive
buffer overruns.
Use the no variant of this command to unset the configured RIPng UDP
receive-buffer size and set it back to the system default of 196608 bits.
recv-buffer-size <8192-2147483647>
Syntax
no recv-buffer-size [<8192-2147483647>]
Default The RIPng UDP receive-buffer-size is 196608 bits by default, and is reset to the
default using the no variant of this command.
Mode Router Configuration
Examples To configure the RIPng UPD, use the following commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
awplus#
awplus(config)#
awplus(config-router)#
C613-50102-01 REV C
configure terminal
router ipv6 rip
recv-buffer-size 23456789
configure terminal
router ipv6 rip
no recv-buffer-size 23456789
configure terminal
router ipv6 rip
no recv-buffer-size
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
880