Allied Telesis AT-x510-28GTX Command Reference Manual page 455

S C
WITCHING OMMANDS
-
PLATFORM LOAD BALANCING
Examples To use all four inputs, you do not have to enter any commands, because this is the
default. Note that this setting is not displayed in the show running-config output.
Use the
To use MAC addresses, IP addresses and Layer 4 port numbers, remove Ethertype
by entering:
awplus#
awplus(config)#
To use MAC addresses and Ethertype, remove the IP inputs by entering:
awplus#
awplus(config)#
src-dest-port
To use MAC addresses only, remove the other inputs by entering:
awplus#
awplus(config)#
src-dest-port ethertype
To use IP addresses and Layer 4 port numbers, remove MAC addresses and
Ethertype by entering:
awplus#
awplus(config)#
ethertype
Related show platform
Commands
C613-50102-01 REV C
show platform command to verify this setting.
configure terminal
no platform load-balancing ethertype
configure terminal
no platform load-balancing src-dst-ip
configure terminal
no platform load-balancing src-dst-ip
configure terminal
no platform load-balancing src-dst-mac
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
455