Atmf Topology-Gui Enable - Allied Telesis AT-x510-28GTX Command Reference Manual

GUI C
OMMANDS
-
ATMF TOPOLOGY GUI ENABLE

atmf topology-gui enable

Overview Use this command to enable the operation of AMF Vista Manager on the Master
device.
Use the no variant of this command to disable this feature.
Syntax atmf topology-gui enable
no atmf topology-gui enable
Default By default the GUI support will not be enabled on AMF Master devices. An AMF
Controller device will have the GUI enabled by default. Regular nodes (not master
or controller) will always have it disabled.
Mode Global Configuration mode
Usage This command is run from an AMF Master node. Topology information about your
network is displayed in the GUI. For example; Node Name, status (i.e. link state,
node status and recovery status), Role (i.e. Master or Controller) and IP address.
Example To enable AMF Vista Manager on Node1, use the following commands:
Node1#
Node1(config)#
To disable AMF Vista Manager on Node1, use the following commands:
Node1#
Node1(config)#
Related atmf enable
Commands
gui-timeout
log event-host
service http
C613-50102-01 REV C
configure terminal
atmf topology-gui enable
configure terminal
no atmf topology-gui enable
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
210