Log Permanent - Allied Telesis AT-x510-28GTX Command Reference Manual

L C
OGGING OMMANDS

LOG PERMANENT

log permanent
Overview This command configures the device to send permanent log messages to
non-volatile storage (NVS) on the device. The content of the permanent log is
retained over a reboot. Once the permanent log reaches its configured maximum
allowable size old messages will be deleted to make way for new messages.
The no variant of this command configures the device not to send any messages
to the permanent log. Log messages will not be retained over a restart.
log permanent
Syntax
no log permanent
Mode Global Configuration
Examples To enable permanent logging use the following commands:
awplus#
awplus(config)#
To disable permanent logging use the following commands:
awplus#
awplus(config)#
Related clear log permanent
Commands
default log permanent
log permanent (filter)
log permanent exclude
log permanent size
show log config
show log permanent
C613-50102-01 REV C
configure terminal
log permanent
configure terminal
no log permanent
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
365