Allied Telesis AT-x510-28GTX Command Reference Manual page 307

P C C
LUGGABLES AND ABLING OMMANDS
SHOW SYSTEM PLUGGABLE DIAGNOSTICS
Output Figure 8-5:
awplus#show system pluggable diagnostics
System Pluggable Information Diagnostics

Port1.0.25
Temp: (Degrees C)
Vcc: (Volts)
Tx Bias: (mA)
Tx Power: (mW)
Rx Power: (mW)
Rx LOS:

Port1.0.26
Temp: (Degrees C)
Vcc: (Volts)
Tx Bias: (mA)
Tx Power: (mW)
Rx Power: (mW)
Rx LOS:
Table 11: Parameters in the output from the show system pluggables
Related show system environment
Commands
show system pluggable
show system pluggable detail
C613-50102-01 REV C
Example output from the show system pluggable diagnostics
command on a device
Status
Reading Alarm
29.387 - 100.00
3.339 - 3.465
10.192 - 37.020
17.872 - 35.643
0.006 Low 15.849
Rx Down
Status
Reading Alarm
29.387 - 100.00
3.378 - 3.630
2.802 - 6.000
2.900 - 11.000
1.739 - 18.000
Rx Up
diagnostics command
Parameter Description
Temp (Degrees C) Shows the temperature inside the transceiver.
Vcc (Volts) Shows voltage supplied to the transceiver.
Tx Bias (mA) Shows current to the Laser Diode in the transceiver.
Tx Power (mW) Shows the amount of light transmitted from the transceiver.
Rx Power (mW) Shows the amount of light received in the transceiver.
Rx LOS Rx Loss of Signal. This indicates whether:
• light is being received (Rx Up) and therefore the link is up, or
• light is not being received (Rx Down) and therefore the link is
down
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Alarms
Max Min Warning
-40.00
3.135
3.260
8.953
0.025 Low
Alarms
Max Min Warning
-40.00
2.970
1.000
0.600
0.000
Warnings
Max Min
- 85.000 -10.00
- 3.400 3.200
- 34.520 5.760
- 28.313 11.271
12.589 0.040
Warnings
Max Min
- 85.000 -10.00
- 3.465 3.135
- 5.000 1.000
- 10.000 0.850
- 10.000 0.200
307