Program 34 : Tie Line Setup; E&M Tie Line Basic Setup - NEC SL2100 Programming Manual

SL2100
Level:
IN
Description
Use Program 34-01 : E&M Tie Line Basic Setup to define the basic settings for each E&M Tie line.
Program
34 Input Data
Item
No.
01 DID/E&M Start
Signaling
02 Receive Dial
Type for E&M Tie
Line
03 E&M Dial-In
Mode
04 E&M Line Dial
Tone
05 System Toll Re-
striction
Conditions
None
Feature Cross Reference
None
2-368
Trunk Port Number
Item Input Data
nd
0 = 2 Dial Tone
1 = Wink
2 = Immediate
3 = Delay
0 = DP
1 = DTMF
2 = MF
0 = Specify Extension
Number (Intercom)
1 = Use Conversion Ta-
ble (NTT)
0 = Disable (No)
1 = Enable (Yes)
0 = System
1 = Each Extension

Program 34 : Tie Line Setup

34-01 : E&M Tie Line Basic Setup
Description
Set the start signaling mode for DID
and Tie trunks. DID and Tie trunks
can use either immediate start or
wink start signaling.
Determine if the incoming Tie Line
call should be directed as an inter-
com call or if it should follow the DID
Translation Table in Program 22-11.
Enter 1 if the Tie Line should send
dial tone to the calling system after
the call is set up. Enter 0 if the Tie
Line should not send dial tone.
Determine if an incoming Tie Line
call should be subject to Toll Restric-
tion. If it is set to 0 then it will use
the Program 21-05-13, if it is set to 1
then it will used Programs 21-05-01
~ 21-05-13.
ISSUE 2.0
1 ~ 128
Default Related
Program
1 22-02
1 10-09
0 22-11
1
0 21-05
Program 34 : Tie Line Setup