Caller Id - NEC SL1000 Getting Started Manual

SL1000 Getting Started Guide

Caller ID

You will need to enable this setting if:

You have Caller ID service supplied on your outside lines.

You have Analog telephones that are Caller ID compatible.
The SL1000 can detect the Caller ID and display it on the LCD display of the SL1000 system phones.
It can also be available at a Analog phone that is Caller ID compatible.
System Operation:
You will need turn on the Caller ID detection for each trunk that it will be received on.
You will also need to turn on Caller ID for each of the Analog telephones that are Caller ID compatible.
Program14-02-10
Turn on Caller ID for each trunk.
Default Setting:
Set 0 to Caller ID is turned off for each trunk .
1. After Log-In to the Programming Mode.
If you already Log-In the programming mode, skip this operation.
2. Dial 14 02 10, For each trunk enter 1 to turn on Caller ID, you can
overwrite the current entry and Press Hold key to confirm the entry and
step to the next option.
3. Press Mute key several times when you are done to return to the
Program Mode.
3. Dial 15 03 09. For each telephone enter 1 to turn on Caller ID, you can
overwrite the current entry and Press Hold key to confirm the entry and
step to the next telephone.
4. Press Mute key several times when you are done to return to the
Program Mode.
5. Press Speaker key to save changes and exit if you are finished.
See Also:
There are no other related settings.
Configuration Sheet: Caller ID
With defaults shown.
Turn on the Caller ID for each trunk.
Prg 14-02-10
Trunk Setting
number Default= 0 Off
Trunk 1
Trunk 2
Trunk 3
Trunk 4
Turn on the Caller ID for each Analog telephone.
Prg 15-03-09
Telephone Setting
Default=0 Off
Operation
38
Display shows;
Program Mode
14-02-10Trunk1
Caller ID 0
15-03-09TEL200
Ext No Display 0