HEADLAMP WASHER RELAY OPEN —
TEST
5
Turn the ignition on.
Disconnect the Headlamp Washer Pump Motor connector.
Actuate the washers.
Measure the voltage of the Washer Pump Output Circuit.
Is the voltage above 10.0 volts?
Yes → Replace the Headlamp Washer Pump Motor.
→ Go To 6
No
6
Turn the ignition off.
Install a known good relay in place of the Headlamp Washer Relay.
Turn the Washers on.
Do the Headlamp Washers operate normally?
Yes → Replace the Headlamp Washer Relay.
→ Replace the Front Control Module.
No
ACTION
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
Perform BODY VERIFICATION TEST - VER 1.
WINDSHIELD WIPER & WASHER
Continued
989
APPLICABILITY
All
All