WINDSHIELD WIPER & WASHER
Symptom:
REAR WIPER OUTPUT OPEN
When Monitored and Set Condition:
REAR WIPER OUTPUT OPEN
When Monitored: Ignition on.
Set Condition: The Output is ON, the Output Driver Status is LOW and there is no Park
signal.
INTERMITTENT WIRING AND CONNECTORS
REAR WIPER MOTOR CONTROL CIRCUIT OPEN
REAR WIPER MOTOR GROUND OPEN
REAR WIPER MOTOR CONTROL CIRCUIT SHORT TO VOLTAGE
REAR WIPER MOTOR
BODY CONTROL MODULE
TEST
1
Ignition on, engine not running.
Turn on the Rear Wiper.
Does the Rear Wiper Function?
Yes → Go To 2
→ Go To 3
No
2
Turn the ignition on.
With the DRBIII , erase all BCM and FCM DTCs.
Turn the ignition off.
The conditions necessary to set this DTC are not present at this time.
Using the schematics as a guide, inspect the wiring and connectors specific to this
circuit.
Wiggle the wiring while checking for shorts and open circuits.
Were there any problems found?
Yes → Repair as necessary.
→ Test Complete.
No
POSSIBLE CAUSES
ACTION
Perform BODY VERIFICATION TEST - VER 1.
994
APPLICABILITY
All
All