Configuring Voice Mail (Vm) Parameters - 3Com VCX v7111 User Manual

Parameter
Answer Supervision
[EnableVoiceDetection]
Rings before Detecting
Caller ID
[RingsBeforeCallerID]
Send Metering Message to
IP
[SendMetering2IP]
Disconnect on Busy Tone
[DisconnectOnBusyTone]
Guard Time Between Calls
[GuardTimeBetweenCalls]
Disconnect on Dial Tone
[DisconnectOnDialTone]

Configuring Voice Mail (VM) Parameters

Use this screen to configure the VM parameters. The VM application applies only to FXO
gateways. For detailed information on VM, see the CPE Configuration Guide for Voice Mail.
148
Description
Yes [1] = FXO gateway sends 200 OK (to INVITE) messages when
speech/fax/modem is detected.
No [0] = 200 OK is sent immediately after the FXO gateway finishes dialing
(default).
Usually this feature is used only with early media establish voice path before the
call is answered.
This feature is applicable only to One Stage dialing.
Sets the number of rings before the gateway starts detection of Caller ID (FXO
only).
0 [0] = Before first ring.
1 [1] = After first ring (default).
2 [2] = After second ring.
No [0] = Disabled (default).
Yes [1] = FXO gateways send a metering tone INFO message to IP on
detection of 12/16 kHz metering pulse. FXS gateways generate the 12/16 kHz
metering tone on reception of a metering message.
Suitable (12 kHz or 16 kHz) coeff must be used for both FXS and FXO
gateways. The MeteringType parameter must be defined in both
FXS/FXO gateways.
The proprietary metering tone INFO message is shown in
Special Applications - Metering Tones
No [0] = Call is not released (FXO gateway).
Yes [1] = Call is released (on FXO gateways) if busy or reorder (fast busy)
tones are detected on the gateways FXO port (default).
Defines the time interval (in seconds) after a call has ended and a new call can
be accepted for IP to Tel calls.
Applicable only to FXO gateways.
The valid range is 0 to 10. The default value is 1 second.
Occasionally, after a call is ended and onhook is applied, a delay is
required before placing a new call (and performing offhook). This is
necessary to prevent wrong hook-flash detection or other glare
phenomena.
FXO gateways can disconnect a call after a dial tone from the PBX is detected.
No [0] = Call is not released.
Yes [1] = Call is released if dial tone is detected on the gateways FXO port
(default).
This option is in addition to the mechanism that disconnects a call
when either busy or reorder tones are detected.
Relay.
®
3Com VCX V7111 VoIP Gateway User Guide
Chapter 11: