3Com VCX v7111 User Manual page 139

To save the changes, see
6
Authentication ini File Parameter
Table 41
Parameter Name in ini File
Authentication_x
Automatic Dialing
Use the Automatic Dialing Table to define telephone numbers that are automatically dialed
when a specific port is used.
To configure the Automatic Dialing table:
Open the Automatic Dialing screen (Protocol Management menu > Endpoint Settings
1
submenu > Automatic Dialing option); the Automatic Dialing screen is displayed.
Automatic Dialing Table Screen
Figure 48
In the Destination Phone Number field for a port, enter the telephone number to dial.
2
From the Auto Dial Status drop-down list, select one of the following:
3
Enable [1]: When a port is selected, when making a call, the number in the
Destination Phone Number field is automatically dialed if phone is offhooked (for FXS
gateways) or ring signal is applied to port (FXO gateways).
Disable [0]: The automatic dialing option on the specific port is disabled (the number
in the Destination Phone Number field is ignored).
Hotline [2]: When a phone is offhooked and no digit is pressed for
HotLineDialToneDuration, the number in the Destination Phone Number field is
automatically dialed (applies to FXS and FXO gateways).
Repeat Step 3 for each port you want to use for Automatic Dialing.
4
®
3Com VCX V7111 VoIP Gateway User Guide
Saving Configuration.
Parameter Format
Authentication_<Port> = <Username>,<Password>
For example:
Authentication_0 = david,14325
Authentication_1 = Alex,18552
Using the sign $$ enables the user to omit either the
username or the password. For instance,
Authentication_5 = $$, 152. In this case, endpoint 5s
phone number is used instead of username.
139