Assigning An Ip Address Using The Cli - 3Com VCX v7111 User Manual

Assigning an IP Address Using the CLI

First access the CLI using a standard Telnet application or using a serial communication
software (for example, HyperTerminal
the CLI). Then assign the V7111 an IP address (see
Access the CLI
To access the CLI using the Embedded Telnet Server:
Enable the Embedded Telnet Server:
1
a) Access the V7111 Embedded Web Server (see
Server).
b) Set the parameter Embedded Telnet Server (under Advanced Configuration >
Network Settings > Application Settings) to Enable (Unsecured) or Enable Secured
(SSL).
c) Click Maintenance on the main menu bar; the Maintenance Actions screen is
displayed.
d) From the Burn to FLASH drop-down list, select Yes.
e) Click Reset; the V7111 is shut down and re-activated. A message about the waiting
period is displayed. The screen is refreshed.
Use a standard Telnet application to connect to the V7111 Embedded Telnet Server.
2
Note that if the Telnet server is set to SSL mode, a special Telnet client is required on
your PC to connect to the Telnet interface over a secured connection.
Login using the username (Admin) and password (Admin).
3
To access the CLI using the RS-232 port:
Connect the RS-232 port to your PC (For the V7111 24 PORT, see
1
V7111 24 PORT RS-232 Port to Your
V7111 1x PORT RS-232 Port to Your
Use serial communication software (for example, HyperTerminal
2
V7111 gateway.
Set your serial communication software to the following communications port settings:
Baud Rate: 115,200 bps (V7111 24 PORT), 9,600 bps (V7111 1x PORT)
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
The CLI prompt becomes available.
®
3Com VCX V7111 VoIP Gateway User Guide
TM
) connected to the V7111 RS-232 port (see
Assign an IP
Accessing the Embedded Web
PC). For the V7111 1x PORT, see
PC).
Access
Address).
Connecting the
Connecting the
TM
) to connect to the
49