Recording Screen - Manual Mode - 3Com VCX v7111 User Manual

•
If the gateway is configured correctly (with a Call Progress Tones dat file loaded
to the gateway), all four Call Progress Tones are detected by the gateway. By
noting whether the gateway detects the tones or not, you can determine how well
the Call Progress Tones dat file matches your PBX. During the first run of the
CPTWizard, it is likely that the gateway does not detect any tones.
•
Some tones cannot be detected by the V7111 gateway hardware (such as 3-
frequency tones and complex cadences). CPTWizard is therefore limited to
detecting only those tones that can be detected on the V7111 gateway.
At this stage, you can either click Next to generate a Call Progress Tones ini file and
terminate the wizard, or continue to manual recording mode.
Recording Screen – Manual Mode
In manual mode you can record and analyze tones, included in the Call Progress Tones ini
file, in addition to those tones analyzed when in automatic mode.
To start recording in manual mode:
Click the Manual tab at the top of the recording screen, the manual recording screen is
1
displayed.
Figure 158 Recording Screen - Manual Mode
Check the play-through check box to hear the tones through your PC speakers.
2
Click the Go offhook button, enter a number to dial in the Dial field, and click the Dial
3
button. When you are ready to record, click the Start Recording button; when the desired
tone is complete, click Stop Recording. (The recorded tone is saved as
cpt_manual_tone.pcm.)
®
3Com VCX V7111 VoIP Gateway User Guide
437