3Com VCX v7111 User Manual page 101

Parameter
Caller ID Type
[CallerIDType]
Hook-Flash Code
[HookFlashCode]
MWI Parameters
Enable MWI
[EnableMWI]
MWI Analog Lamp
[MWIAnalogLamp]
MWI Display
[MWIDisplay]
Subscribe to MWI
[EnableMWISubscription]
MWI Server IP Address
[MWIServerIP]
®
3Com VCX V7111 VoIP Gateway User Guide
Description
Defines one of the following standards for detection (FXO) and generation
(FXS) of Caller ID and detection (FXO) of MWI (when specified) signals.
Bellcore [0] (Caller ID and MWI) (default).
ETSI [1] (Caller ID and MWI)
NTT [2]
British [4]
DTMF ETSI [16]
Denmark [17] (Caller ID and MWI)
India [18]
Brazil [19]
The Caller ID signals are generated/detected between the first
and the second rings.
To select the Bellcore Caller ID sub standard, use the
parameter BellcoreCallerIDTypeOneSubStandard. To select
the ETSI Caller ID sub standard, use the parameter
ETSICallerIDTypeOneSubStandard.
To select the Bellcore MWI sub standard, use the parameter
BellcoreVMWITypeOneStandard. To select the ETSI MWI sub
standard, use the parameter ETSIVMWITypeOneStandard.
Determines a digit pattern which, when received from the Tel side, indicates a
Hook Flash event.
The valid range is a 25-character string.
Enable MWI (message waiting indication).
Disable [0] = Disabled (default).
Enable [1] = MWI service is enabled.
This parameter is applicable only to FXS gateways.
The V7111 only supports reception of MWI.
For detailed information on MWI, see
Disable [0] = Disable (default).
Enable [1] = Enable visual Message Waiting Indication, supplies line voltage
of approximately 100 VDC to activate the phones lamp.
This parameter is applicable only to FXS gateways.
Disable [0] = MWI information is not sent to display (default).
Enable [1] = MWI information is sent to display.
If enabled, the gateway generates an MWI FSK message that is displayed on
the MWI display.
This parameter is applicable only to FXS gateways.
Disable [0] = Disable MWI subscription (default).
Enable [1] = Enable subscription to MWI (to MWIServerIP address).
Use the parameter SubscriptionMode (described in
determine whether the gateway subscribes separately per endpoint of
for the entire gateway.
MWI server IP address. If provided, the gateway subscribes to this IP address.
Can be configured as a numerical IP address or as a domain name. If not
configured, the Proxy IP address is used instead.
Message Waiting Indication.
Table 49) to
101