3Com VCX v7111 User Manual page 205

Board, ini File Parameters
Table 69
ini File Parameter Name
LifeLineType
EnableDiagnostics
EnableParametersMonitoring
WatchDogStatus
DisableRS232
DisableWebTask
ResetWebPassword
DisableWebConfig
HTTPport
HeartBeatDestIP
®
3Com VCX V7111 VoIP Gateway User Guide
Valid Range and Description
The Lifeline is activated on:
0 = Power down (default)
1 = Power down or when link is down (physical disconnect)
2 = Power down or when link is down or on network failure (logical
link disconnect)
To enable Lifeline switching on network failure, LAN watch
dog must be activated (EnableLANWatchDog=1).
Checks the correct functionality of the different hardware components
on the gateway. On completion of the check, if the test fails, the
gateway sends information on the test results of each hardware
component to the Syslog server.
0 = Rapid self-test mode (default).
1 = Detailed self-test mode (full test of DSPs, PCM, Switch, LAN,
PHY and Flash).
2 = A quicker version of the Detailed self-test mode (full test of DSPs,
PCM, Switch, LAN, PHY, but partial test of Flash).
For detailed information, see Self-Testing.
Obsolete parameter, use the parameter ActivityListToLog instead.
0 = Disable gateways watch dog.
1 = Enable gateways watch dog (default).
0 = RS-232 serial port is enabled (default).
1 = RS-232 serial port is disabled.
The RS-232 serial port can be used to change the networking
parameters (see Assigning an IP Address Using the
error / notification messages.
For information on establishing a serial communications link with the
V7111, see Establishing a Serial Communications Link with the
V7111).
0 = Enable Web management (default)
1 = Disable Web management
Resets the username and password of the primary and secondary
accounts to their defaults.
0 = Password and username retain their values (default).
1 = Password and username are reset (for the default username and
password, see Table 14).
The username and password cannot be reset from the Web
(that is, using AdminPage or by loading an ini file).
0 = Enable changing parameters from Web (default)
1 = Operate Web server in read only mode
HTTP port used for Web management (default = 80)
Destination IP address (in dotted format notation) to which the
gateway sends proprietary UDP ping packets.
The default IP address is 0.0.0.0.
CLI) and to view
205