3Com VCX v7111 User Manual page 379

Cadence
Burst
Low Freq [Hz]: Frequency in hertz of the lower tone component in case of dual
frequency tone, or the frequency of the tone in case of single tone (not relevant to
AM tones).
High Freq [Hz]: Frequency in hertz of the higher tone component in case of dual
frequency tone, or zero (0) in case of single tone (not relevant to AM tones).
Low Freq Level [-dBm]: Generation level 0 dBm to –31 dBm in [dBm] (not relevant
to AM tones).
High Freq Level: Generation level. 0 to –31 dBm. The value should be set to 32 in
the case of a single tone (not relevant to AM tones).
First Signal On Time [10 msec]: Signal On period (in 10 msec units) for the first
cadence on-off cycle. For be continuous tones, this parameter defines the detection
period. For burst tones, it defines the tones duration.
First Signal Off Time [10 msec]: Signal Off period (in 10 msec units) for the first
cadence on-off cycle (for cadence tones). For burst tones, this parameter defines the
off time required after the burst tone ends and the tone detection is reported. For
continuous tones, this parameter is ignored.
Second Signal On Time [10 msec]: Signal On period (in 10 msec units) for the
second cadence on-off cycle. Can be omitted if there is not a second cadence.
Second Signal Off Time [10 msec]: Signal Off period (in 10 msec units) for the
second cadence on-off cycle. Can be omitted if there is not a second cadence.
Third Signal On Time [10 msec
cadence ON-OFF cycle. Can be omitted if there is not a third cadence.
Third Signal Off Time [10 msec
cadence ON-OFF cycle. Can be omitted if there is not a third cadence.
Forth Signal On Time [10 msec
cadence ON-OFF cycle. Can be omitted if there is not a fourth cadence.
Forth Signal Off Time [10 msec
cadence ON-OFF cycle. Can be omitted if there is not a fourth cadence.
Carrier Freq [Hz ]: the frequency of the carrier signal for AM tones.
Modulation Freq [Hz]: the frequency of the modulated signal for AM tones (valid
range from 1 Hz to 128 Hz).
Signal Level [-dBm]: the level of the tone for AM tones.
AM Factor [steps of 0.02]: the amplitude modulation factor (valid range from 1 to
50. Recommended values from 10 to 25).
®
3Com VCX V7111 VoIP Gateway User Guide
]: Signal On period (in 10 msec units) for the third
]: Signal Off period (in 10 msec units) for the third
]: Signal On period (in 10 msec units) for the fourth
]: Signal Off period (in 10 msec units) for the fourth
379