Restoring Networking Parameters To Their Initial State; Configuring The Vcx V7122 Basic Parameters - 3Com VCX V7122 User Manual

Voip sip gateway
Hide thumbs Also See for VCX V7122:
Table of Contents

Advertisement

Restoring Networking Parameters to Their Initial State

You can use the 'Reset' button to restore the VCX V7122 networking parameters to their
factory default values (described in
password.
Note that this process also restores the VCX V7122 parameters to their factory settings,
therefore you must load your previously backed-up ini file, or the default ini file (received with
the software kit) to set them to their correct values.
This option is currently supported on one media gateway module (trunks 1-8) only.
To restore networking parameters to their initial state, follow these steps:
1
Disconnect the VCX V7122 from the power and network cables.
2
Reconnect the power cable; the gateway is powered up. After approximately 45 seconds,
the ACT LED blinks for about 4 seconds.
3
While the ACT LED is blinking, press shortly on the reset button (located on the front
panel); the gateway resets a second time and is restored with factory default parameters
(username: "Admin", password: "Admin").
4
Reconnect the network cable.
5
Load your previously backed-up ini file, or the default ini file (received with the software
kit). To load the ini file via the Embedded Web Server, see
Gateway Configuration

Configuring the VCX V7122 Basic Parameters

To configure the VCX V7122 basic parameters use the Embedded Web Server's 'Quick
Setup' screen (see
Figure 15
for information on accessing the 'Quick Setup' screen.
3Com VCX V7122 SIP VoIP Gateway User Manual
Table 14
on page 35) and to reset the username and
on page 72.
below). See
Accessing the Embedded Web Server
Restoring and Backing Up the
on page
42
37

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VCX V7122 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents