3Com VCX v7111 User Manual page 150

Parameter
Line Transfer Mode
[LineTransferMode]
Digit Patterns
The following digit pattern parameters apply only to VM applications that use the DTMF communication
method. For the available patterns syntaxes, see the CPE Configuration Guide for Voice Mail.
Forward on Busy Digit Pattern
[DigitPatternForwardOnBusy
Forward on No Answer Digit Pattern
[DigitPatternForwardOnNoAnswer]
Forward on Do Not Disturb Digit
Pattern
[DigitPatternForwardOnDND]
Forward on No Reason Digit Pattern
[DigitPatternForwardNoReason]
Internal Call Digit Pattern
[DigitPatternInternalCall]
External Call Digit Pattern
[DigitPatternExternalCall]
Disconnect Call Digit Pattern
[TelDisconnectCode]
MWI
MWI Off Digit Pattern
[MWIOffCode]
MWI On Digit Pattern
[MWIOnCode]
SMDI
150
Description
Determines the transfer method used by the gateway.
Disable [0] = IP (default).
Blind Transfer [1] = PBX blind transfer. In this mode, after receiving a
REFER message from the IP side, the FXO: sends a hook-flash to the
PBX, dials the digits (that are received in the Refer-To header), and
then immediately drops the line (on-hook). The PBX performs the
transfer internally.
Determines the digit pattern used by the PBX to indicate call forward
] on busy.
The valid range is a 120-character string.
Determines the digit pattern used by the PBX to indicate call forward
on no answer.
The valid range is a 120-character string.
Determines the digit pattern used by the PBX to indicate call forward
on do not disturb.
The valid range is a 120-character string.
Determines the digit pattern used by the PBX to indicate call forward
with no reason.
The valid range is a 120-character string.
Determines the digit pattern used by the PBX to indicate an internal
call.
The valid range is a 120-character string.
Determines the digit pattern used by the PBX to indicate an external
call.
The valid range is a 120-character string.
Determines a digit pattern that, when received from the Tel side,
indicates the gateway to disconnect the call.
The valid range is a 25-character string.
Determines a digit code used by the gateway to notify the PBX that
there are not any messages waiting for a specific extension. This code
is added as prefix to the dialed number.
The valid range is a 25-character string.
Determines a digit code used by the gateway to notify the PBX of
messages waiting for a specific extension. This code is added as
prefix to the dialed number.
The valid range is a 25-character string.
®
3Com VCX V7111 VoIP Gateway User Guide