3Com VCX v7111 User Manual page 294

Example of VLAN and Multiple IPs Configuration
Table 84
Network
IP Address
Type
OAM 10.31.174.50
Control 10.32.174.50
Media 10.33.174.50
Note that since a default gateway is available only for the Media network, for the V7111
gateway to be able to communicate with an external device / network on its OAM and
Control networks, IP routing rules must be used.
The values provided in
Using the ini File
actual values appropriate to your system.
Integrating Using the Embedded Web Server
To integrate the V7111 gateway into a VLAN and multiple IPs network using the Embedded
Web Server:
Access the Embedded Web Server (see
1
Use the Software Upgrade Wizard (see
2
firmware version to the V7111 gateway (VLANs and multiple IPs support is available only
when the firmware is burned to flash).
Configure the VLAN parameters by completing the following steps:
3
Open the VLAN Settings screen (Advanced Configuration menu > Network Settings >
VLAN Settings option); the VLAN Settings screen is displayed.
Modify the VLAN parameters to correspond to the values shown in
Figure 106 Example of the VLAN Settings Screen
Click the Submit button to save your changes.
294
Subnet Mask
255.255.0.0
255.255.0.0
255.255.0.0
Integrating Using the Embedded Web Server
are sample parameter values only and are to be replaced with
Accessing the Embedded Web
Software Upgrade
Default
VLAN ID
Gateway IP
Address
0.0.0.0 4
0.0.0.0 5
10.33.0.1 6
Wizard) to load and burn the
®
3Com VCX V7111 VoIP Gateway User Guide
External
Routing Rule
83.4.87.X
130.33.4.6
--
and Integrating
Server).
Figure 106.