Traps - 3Com VCX v7111 User Manual

The following are special notes pertaining to MIBs:
•
A detailed explanation of each parameter can be viewed in an SNMP browser in
the MIB Description field.
•
Not all groups in the MIB are functional. See version release notes.
•
Certain parameters are non-functional. Their MIB status is marked 'obsolete'.
•
When a parameter is set to a new value using SNMP, the change may affect
device functionality immediately or may require that the device be soft reset for
the change to take effect. This depends on the parameter type.
The current (updated) device configuration parameters are programmed into the
device provided that the user does not load an ini file to the device after reset.
Loading an ini file after reset overrides the updated parameters.
Additional MIBs are to be supported in future releases.

Traps

As of this version all traps are sent from the SNMP port (default 161). This is part of
the NAT traversal solution.
Full proprietary trap definitions and trap Varbinds are found in the acBoard MIB and acAlarm
MIBs. The following proprietary traps are supported. For detailed information on these traps,
see Appendix E: SNMP
Figure 138 Proprietary Traps Description
Trap
acBoardFatalError
acBoardConfigurationError
acBoardTemperatureAlarm
acBoardEvResettingBoard
acBoardEvBoardStarted
acgwAdminStateChange
acOperationalStateChange
acBoardCallResourcesAlarm
®
3Com VCX V7111 VoIP Gateway User Guide
Traps.
Description
Sent whenever a fatal device error occurs.
Sent when a device's settings are illegal. The trap contains a
message describing the illegality of the setting.
Note: Not applicable to IPM-260).
Sent when a board exceeds its temperature limits.
Sent after the device is reset.
Sent after the device is successfully restored and initialized
following reset.
Sent when Graceful Shutdown commences and ends.
Sent if the operational state of the node changes to disabled.
Cleared when the operational state of the node changes to
enabled.
Sent when no free channels are available.
361