3Com VCX v7111 User Manual page 140

Click Submit to save your changes.
5
To save the changes so they are available after a power fail, see
6
After a ring signal is detected, on an Enabled FXO port, the gateway initiates a call to
the destination number without seizing the line. The line is seized only after the call is
answered.
After a ring signal is detected on a Disabled or Hotline FXO port, the gateway seizes
the line.
Automatic Dialing ini File Parameter
Table 42
Parameter Name in ini File
TargetOfChannelX
Caller ID
Use the Caller Display Information screen to send (to IP) Caller ID information when a call is
made using the VoIP gateway (relevant to both FXS and FXO). The person receiving the call
can use this information for caller identification. The information on this table is sent in an
INVITE message in the From header. For information on Caller ID restriction according to
destination / source prefixes, see
If Caller ID name is detected on an FXO line (EnableCallerID = 1), it is used instead
of the Caller ID name defined in this table (FXO gateways only).
To configure the Caller ID table:
Open the Caller Display Information screen (Protocol Management menu > Endpoint
1
Settings submenu > Caller ID option); the Caller Display Information screen is displayed.
140
Parameter Format
TargetOfChannel<Port> = <Phone>,<Mode>
For example:
TargetOfChannel0 = 1001,1
TargetOfChannel3 = 911,2
The numbering of channels starts with 0.
Define this parameter for each gateway port you want to use
for Automatic Dialing.
This parameter can appear up to 8 times for 8-port gateways
and up to 24 times for V7111 24 PORT gateways.
Configuring the Number Manipulation
3Com
Saving
Tables.
®
VCX V7111 VoIP Gateway User Guide
Configuration.