3Com VCX v7111 User Manual page 197

Parameter
Device Behavior Upon RADIUS
Timeout
[BehaviorUponRadiusTimeout]
Local RADIUS Password Cache
Mode
[RadiusLocalCacheMode]
Local RADIUS Password Cache
Timeout
[RadiusLocalCacheTimeout]
RADIUS VSA Vendor ID
[RadiusVSAVendorID]
RADIUS VSA Access Level
Attribute
[RadiusVSAAccessAttribute]
EtherDiscover Settings
EtherDiscover Operation Mode
SRTP Settings
Enable Media Security
[EnableMediaSecurity]
Media Security Behavior
[MediaSecurityBehaviour]
IPSec Settings
®
3Com VCX V7111 VoIP Gateway User Guide
Description
Defines the gateways operation if a response is not received from the
RADIUS server after the 5 seconds timeout expires:
Deny Access [0] = the gateway denies access to the Web and Telnet
embedded servers.
Verify Access Locally [1] = the gateway checks the local username and
password (default).
Defines the gateways mode of operation regarding the timer (configured
by the parameter RadiusLocalCacheTimeout) that determines the validity
of the username and password (verified by the RADIUS server).
Absolute Expiry Timer [0] = when you access a Web screen, the timeout
does not reset but rather continues decreasing.
Reset Timer Upon Access [1] = upon each access to a Web screen, the
timeout always resets (reverts to the initial value configured by
RadiusLocalCacheTimeout).
Defines the time (in seconds) the locally stored username and password
(verified by the RADIUS server) are valid. When this time expires, the
username and password becomes invalid and a must re-verified with the
RADIUS server.
The valid range is 1 to 0xFFFFFF. -1 = Never expires. 0 = Each request
requires RADIUS authentication.
The default value is 300 (5 minutes).
Defines the vendor ID the gateway accepts when parsing a RADIUS
response packet.
The valid range is 0 to 0xFFFFFFFF. The default value is 5003.
Defines the code that indicates the access level attribute in the Vendor
Specific Attributes (VSA) section of the received RADIUS packet.
The valid range is 0 to 255. The default value is 35.
N/A.
Enables or disables the Secure Real-Time Transport Protocol (SRTP).
Disable (TGCP) [0] = SRTP is disabled (default).
Enable (SRTP) [1] = SRTP is enabled.
Use of SRTP reduces the number of available channels.
V7111 24 PORT 18 available channels
V7111 18 PORT 6 available channels
V7111 14 PORT 3 available channels
V7111 12 PORT no reduction.
Determines the gateway's mode of operation when SRTP is used
(EnableMediaSecurity = 1).
Prefer [0] = The gateway initiates encrypted calls. If negotiation of the
cipher suite fails, an unencrypted call is established. Incoming calls that
don't include encryption information are accepted.
Must [1] = The gateway initiates encrypted calls. If negotiation of the
cipher suite fails, the call is terminated. Incoming calls that don't include
encryption information are rejected (default).
197