3Com VCX v7111 User Manual page 296

Figure 108 Example of the IP Routing Table Screen
Use the Add a new table entry pane to add the routing rules shown in
Example of IP Routing Table Configuration
Table 85
Destination IP
Address
130.33.4.6
83.4.87.6
Click the Submit button to save your changes.
Save your changes to flash so they are available after a power fail, see
6
Configuration.
Reset the gateway (see
7
Integrating Using the ini File
To integrate the V7111 gateway into a VLAN and multiple IPs network using the ini file:
Prepare an ini file with parameters shown in
1
If the BootP/TFTP utility and the OAM interface are located in the same network, the
Native VLAN ID (VlanNativeVlanId) must be equal to the OAM VLAN ID
(VlanOamVlanId), which in turn must be equal to the PVID of the switch port the gateway
is connected to. Therefore, set the PVID of the switch port to 4 (in this example).
Configure the OAM parameters (LocalOAMPAddress, LocalOAMSubnetMask and
LocalOAMDefaultGW) only if the OAM networking parameters are different from the
networking parameters used in the Single IP Network mode.
The IP Routing table is required to define static routing rules for the OAM and Control
networks since a default gateway is not supported for these networks.
296
Destination Mask
255.255.255.255
255.255.255.0
Resetting the V7111
Gateway IP
Address
10.32.0.1 20
10.31.0.1 20
Gateway).
Figure 96 (see the following notes):
®
3Com VCX V7111 VoIP Gateway User Guide
Table 85.
Hop Network
Count Type
Control
OAM
Saving