Component: Ethernetlink#0 - 3Com VCX v7111 User Manual

Probable Cause:
Alarm Text:
Status Changes:
Condition:
Alarm status:
Condition:
Alarm status:
Note:
Corrective Action:

Component: EthernetLink#0

The source varbind text for all the alarms under this component is
Board#<n>/EthernetLink#0 where n is the slot number. This trap relates to the Ethernet Link
Module (the #0 numbering does not apply to the physical Ethernet link).
acBoardEthernetLinkAlarm Alarm Trap
Table 127
Alarm:
OID:
Default Severity:
Event Type:
Probable Cause:
Alarm Text:
Status Changes:
Condition:
Alarm status:
<text> value:
Condition:
Alarm status:
<text> value:
®
3Com VCX V7111 VoIP Gateway User Guide
resourceAtOrNearingCapacity (43)
Active alarm table overflow
Too many alarms to fit in the active alarm table
Major
After raise
Status stays major until reboot. A clear trap is not sent.
The status stays major until reboot as it denotes a possible loss of information
until the next reboot. If an alarm is raised when the table is full, it is possible
that the alarm is active, but does not appear in the active alarm table.
Some alarm information may have been lost, but the ability of the device to
perform its basic operations has not been impacted. A reboot is the only way to
completely clear a problem with the active alarm table. Contact your first-level
group.
acBoardEthernetLinkAlarm
1.3.6.1.4.1.5003.9.10.1.21.2.0.10
Critical
equipmentAlarm
underlyingResourceUnavailable (56)
Ethernet link alarm: <text>
Fault on single interface
major
Redundant link is down
Fault on both interfaces
critical
No Ethernet link
447