3Com VCX v7111 User Manual page 170

ini File Parameter Name
PPPoEPassword
PPPoEServerName
PPPoEStaticIPAddress
PPPoERecoverIPAddress
PPPoERecoverSubnetMask
PPPoERecoverDfgwAddress
PPPoELCPEchoEnable
EthernetPhyConfiguration
170
Valid Range and Description
Password for PAP or Secret for CHAP authentication. The valid range
is a string of up to 47 characters. The default value is 0.
Server Name for CHAP authentication. The valid range is a string of
up to 47 characters. The default value is 0.
IP address to use in a static configuration setup. If set, used during
PPP negotiation to request this specific IP address from the PPP
server. If approved by the server, this IP address is used during the
session.
The valid IP address range is in dotted notation xxx.xxx.xxx.xxx. The
default value is 0.0.0.0.
IP address to use when booting from the flash to non-PPPoE (Point-
to-Point Protocol over Ethernet) environments.
The valid IP address range is in dotted notation xxx.xxx.xxx.xxx. The
default value is 10.4.10.4.
Subnet Mask to use when booting from the flash to non-PPPoE
(Point-to-Point Protocol over Ethernet) environments.
The valid IP address range is in dotted notation xxx.xxx.xxx.xxx. The
default value is 255.255.0.0.
Default GW address to use when booting from the flash to non-
PPPoE (Point-to-Point Protocol over Ethernet) environments.
The valid IP address range is in dotted notation xxx.xxx.xxx.xxx. The
default value is 10.4.10.1.
Enables or disables the Point-to-Point Protocol over Ethernet (PPPoE)
disconnection auto-detection feature.
Valid options include:
[0] = Disable
[1] = Enable (default)
By default, the PPPoE Client (that is, embedded in the gateway) sends
LCP Echo packets to the server to check that the PPPoE connection is
open. Some Access Concentrators (PPPoE servers) don't reply to
these LCP Echo requests, resulting in a disconnection. By disabling
the LCP disconnection auto-detection feature, the PPPoE Client does
not send LCP Echo packets to the server (and does not detect PPPoE
disconnections).
0 = 10 Base-T half-duplex.
1 = 10 Base-T full-duplex.
2 = 100 Base-TX half-duplex.
3 = 100 Base-TX full-duplex.
4 = Auto-Negotiate (default).
For detailed information on Ethernet interface configuration, see
Ethernet Interface Configuration.
3Com
®
VCX V7111 VoIP Gateway User Guide