front bearing retainer Plate.
# #
1 2 . R e m o v e t h e
Support the drive-end housing in a vise, and drive
out the front bearing with a brass drift and hammer'
14. With a hammer and the special tools, install a new
front bearing in the drive-end housing
07749-0010000
077 ir5-001 0400
Alternator Brush InsPection
15. Measure the length of both brushes with a vernier
c a l i p e r .
' l f e i t h e r b r u s h i s s h o r t e r t h a n t h e s e r v i c e l i m i t ,
replace the rear housing assembly.
. lf brush length is OK, goto step 16
Alternator Brush Length:
Standard (New): 19.0 mm (0.75 in.)
Service Limit:
5.0 mm (0.2 in.)
(cont'd)
4-39