Acura 2002 RSX Service Manual page 58

Brush Spring lnspection (K20M enginel
1 5 . I n s e n t h e b r u s h ( A ) i n t o t h e b r u s h h o l d e r , a n d b r i n g
the brush into contact with the commutator, then
attach a spring scale (B) to the spring {C). Measure
the spring tension at the moment the spring lifts off
the brush. lf the spring tension is not within
specification, replace the spring.
Spring Tension: 13.7 17.7N(1.40 1.80 kgf,
3.09 3.97 lbf)
Planetary Gear Inspection
1 6 . C h e c k t h e p l a n e t a r y g e a r s ( A ) a n d r i n g g e a r ( B ) .
Replace them if they are worn or damaged.
1 8 .
1 9 .
Overrunning Clutch Inspection (l(20A3 enqine)
17. Holding the drive gear (A), turn the gear shaft {B)
clockwise. Check that the drive gear comes out to
the other end. lf the drive gear does not move
smoothly, replace the gear cover assembly.
B
Holding the drive gear, turn the gear shaft
counterclockwise. The gear shaft should rotate
freely. lf the gear shaft does not rotate smoothly,
replace the gear cover assemblY.
lf the starter drive gear is worn or damaged.
replace the overrunning clutch assembly; the gear
is not available separately.
Check the condition of the flywheel or torque
converter ring gear. Replace it if the staner drive
gear teeth are damaged.
(cont'd)
4-17