Ford Ranger Maintaince And Repair Manual page 703

8. Disconnect the speedometer cable from the cluster. The cable connection has a flat surface clip; press
the clip inward and pull the cable from the cluster.
9. Disconnect the wire harness plugs from the cluster and remove it from the dash.
To install:
10. Apply approximately
the speedometer head.
11. Position the instrument cluster near its opening and attach the electrical plugs to it.
12. Connect the speedometer cable to the speedometer head. If necessary, reconnect the speedometer
cable to the transmission.
13. If removed, install the two PRNDL indicator retaining screws.
14. Insert the cluster into the dash and install the four attaching screws.
15. Ensure that the hazard warning switch is depressed and install the cluster trim panel.
16. Connect the negative battery cable. Start the vehicle and check all gauges, lamps and signals for
proper operation.
1995−99 Models
1. Disconnect the negative battery cable.
2. Remove the radio.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
View of the speedometer cable end at the instrument cluster
Click to enlarge
3
/ inch (4.8mm) diameter ball of silicone dielectric grease in the drive hole of
16
707