Ford Ranger Maintaince And Repair Manual page 870

Hide thumbs Also See for Ranger:

Table of Contents

With the seal removed, the inner bearing may be withdrawn from the hub

If the cups are worn or damaged, remove them with front hub remover tool T81P−1104−C and tool

T77F−1102−A or equivalent.

Wipe the old grease from the spindle. Check the spindle for excessive wear or damage. Replace

defective parts, as required.

If the inner and outer cups were removed, use bearing driver handle tool T80−4000−W or equivalent

and replace the cups. Be sure to seat the cups properly in the hub.

Use a bearing packer tool and properly repack the wheel bearings with the proper grade and type

grease. If a bearing packer is not available work as much of the grease as possible between the rollers

and cages. Also, grease the cone surfaces.

Thoroughly pack the bearing with fresh, high temperature wheel bearing grease

Position the inner bearing cone and roller assembly in the inner cup. A light film of grease should be

included between the lips of the new grease retainer (seal).

HOW TO USE THIS BOOK

REMOVAL & INSTALLATION

Troubleshooting

Mountaineer Explorer