Ford Ranger Maintaince And Repair Manual page 264

Hide thumbs Also See for Ranger:

Table of Contents

Remove the front engine support insulator−to−crossmember retaining fasteners.

If equipped, remove the engine damper mounting bracket from the engine. The bracket may use two

TORX® bolts for the lower mounting points.

Partially lower the vehicle and support it with jackstands in the new position.

Support the transmission with a floor jack.

Using a engine crane or hoist, lift the engine out of the vehicle. Be sure to lift the engine slowly and

check often that nothing (such as wires, hoses, etc.) will cause the engine to hang up on the vehicle.

At this point, the engine can be installed on an engine stand.

Lightly oil all bolts and stud threads, except those specifying special sealant, prior to installation.

Using the hoist or engine crane, slowly and carefully position the engine in the vehicle. Make sure the

exhaust manifolds are properly aligned with the exhaust pipes.

Align the engine to the transmission and install two engine−to−transmission bolts.

REMOVAL & INSTALLATION

HOW TO USE THIS BOOK

Engine damper mounting for 4.0L engines

Click to enlarge

Troubleshooting

Mountaineer Explorer