Ford Ranger Maintaince And Repair Manual page 822

With the axle supported, remove the left front axle−to−frame bolt first
Remove the two remaining axle−to−frame attaching bolts then lower the axle housing
The manufacturer recommends using new fasteners when installing the front axle. Before beginning
this procedure, make sure to acquire new mounting bolts.
1. Remove the front axle halfshafts. Refer to axle shaft and seal procedures earlier in this Section.
2. Matchmark the front driveshaft to the front axle companion flange.
3. Unbolt the front driveshaft retaining straps from the front axle assembly and support it out of the way.
Do not allow the driveshaft to hang unsupported, damage to the shaft and or U−joint can occur.
4. Disconnect the axle vent tube.
5. Place a jack under the front axle to support it.
6. Remove the left front axle−to−frame attaching bolt.
7. Remove the remaining two axle−to−frame bolts.
8. Lower the axle assembly and remove it from under the vehicle.
To install:
9. Place the axle assembly on a jack and position it under the vehicle.
10. Raise the axle assembly up and align the three mounting holes.
11. Install the three mounting bolts and tighten them to 45−59 ft. lbs. (60−90 Nm).
12. Connect the axle vent tube.
13. Install the front driveshaft to the axle companion flange, aligning the matchmarks made earlier, then
install the retaining straps and tighten the bolts.
834
HOW TO USE THIS BOOK
WARNING
REMOVAL & INSTALLATION