Ford Ranger Maintaince And Repair Manual page 668

Remove the blower motor attaching screws and the washer fluid reservoir ...
... then slide the blower motor from the housing. Take care to not damage the blower wheel
6. Remove the 2 screws attaching the blower motor and wheel to the heater blower assembly.
7. Holding the cooling tube aside, pull the blower motor and wheel from the heater blower assembly and
remove it from the vehicle.
8. Remove the blower wheel push−nut and/or clamp from the motor shaft and pull the blower wheel
from the motor shaft.
To install:
9. Install the blower wheel on the blower motor shaft.
10. Install the hub clamp and/or push−nut.
11. Holding the cooling tube aside, position the blower motor and wheel on the heater blower assembly
and install the 2 attaching screws.
12. Connect the blower motor cooling tube and the wire harness connector.
13. Install the vacuum reservoir on the hoses with the 1 screws.
14. If removed, install the speed control module and the washer fluid reservoir.
15. Install the air cleaner or air inlet duct, as necessary.
16. Connect the negative battery cable and check the system for proper operation.
With Air Conditioning
1. Disconnect the negative battery cable.
2. In the engine compartment, disconnect the wire harness from the motor by pushing down on the tab
while pulling the connection off at the motor.
3. Remove the air cleaner or air inlet duct, as necessary.
4. If necessary, remove the solenoid box cover retaining bolts and the solenoid box cover.
5. Disconnect the blower motor cooling tube from the blower motor.
6. Remove the blower motor mounting plate attaching screws and remove the motor and wheel assembly
from the evaporator assembly blower motor housing.
7. Remove the blower motor hub clamp from the motor shaft and pull the blower wheel from the shaft.
To install:
8. Install the blower motor wheel on the blower motor shaft and install a new hub clamp.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
(arrow)
671