Water Pump - Ford Ranger Maintaince And Repair Manual

5. Remove the fan/clutch assembly and the fan shroud together.
6. If necessary, remove the fan−to−clutch bolts to separate the fan from the clutch.
To install:
7. Installation is the reverse of removal. Torque the fan−to−clutch bolts to 55−70 inch lbs. (6−8 Nm);
the hub nut to 30−100 ft. lbs. (41−135 Nm) for 1991−95 models and 34−46 ft. lbs. (46−63 Nm) for
1996−99 models. Don't forget, the nut uses RH threads and is tightened clockwise.
4.0L SOHC (VIN E) and 5.0L Engines
1. If necessary, remove the air cleaner outlet tube.
2. Using Fan Clutch Pulley Holder T84T−6312−C and Fan Clutch Nut Wrench T84T−6312−D for the
4.0L engine, or Holder T96T−6312−A and Wrench T96T−6312−B for the 5.0L engine, loosen the
large nut attaching the clutch to the water pump hub.
The manufacturer does not specify a loosening or tightening direction. Using extreme care, try loosening the
nut in one direction first. If it does not move, change directions. Applying too much force to the end of the
water pump will break it.
3. Remove the two upper fan shroud retaining bolts. If the overflow hose is routed through the fan
shroud, remove it from the shroud.
4. Lift up on the fan shroud to disengage the lower mounting clips.
5. Remove the fan/clutch assembly and the fan shroud together.
6. If necessary, remove the fan−to−clutch bolts to separate the fan from the clutch.
To install:
7. Installation is the reverse of removal. Torque the fan−to−clutch bolts to 14−19 ft. lbs. (19−26 Nm);
the hub nut to 34−46 ft. lbs. (46−63 Nm). Tighten the nut in the reverse direction of removal.

Water Pump

REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
Remove the fan and clutch assembly from the vehicle
WARNING
323