Before pulling the wheel from the shaft, make a matchmark on the shaft and wheel
7.
Remove the tool and the steering wheel retaining bolt then lift off the steering wheel.
8.
Installation is the reverse of the removal procedure. Be sure that the steering wheel is properly aligned
before installing the lock bolt. Torque the steering wheel lock bolt to 23−33 ft. lbs. (31−45 Nm).
1995−99 Models
Whenever working on a vehicle equipped with an air bag, always refer to Section 6 for disarming procedures.
Follow the procedures outlined or severe injury, or even death may occur.
The manufacturer recommends installing the steering wheel using a new wheel−to−shaft retaining bolt.
Before beginning this procedure, obtain a new bolt.
1.
Follow the procedures in Section 6 and disarm the air bag.
942
HOW TO USE THIS BOOK
Finish by pulling the steering wheel from the column shaft
CAUTION
REMOVAL & INSTALLATION