Ford Ranger Maintaince And Repair Manual page 966

Hide thumbs Also See for Ranger:

Table of Contents

Use two wrenches to loosen the fitting. If available, use flare nut type wrenches

Disconnect the other end of the line or hose, moving the drain pan if necessary. Always use a

back−up wrench to avoid damaging the fitting.

Disconnect any retaining clips or brackets holding the line and remove the line from the vehicle.

If the brake system is to remain open for more time than it takes to swap lines, tape or plug each

remaining clip and port to keep contaminants out and fluid in.

Any gaskets/crush washers should be replaced with new ones during installation

HOW TO USE THIS BOOK

REMOVAL & INSTALLATION

Troubleshooting

Mountaineer Explorer