Relay Replacement - Ford Ranger Maintaince And Repair Manual

4. Remove the starter mounting bolts and remove the starter.
... then remove the starter−be careful, the starter motor can be quite heavy
To install:
5. Position the starter motor against the engine and install the mounting bolts. Tighten the mounting
bolts to 15−19 ft. lbs. (21−27 Nm).
6. Install the starter solenoid connector by pushing it straight on. Ensure that the connector locks in
position with a notable click.
Install the starter cable nut to the starter solenoid B−terminal. Tighten the nut to 80−123 inch lbs. (9−14 Nm).
7. Connect any remaining wiring to the starter motor.
8. Lower the front of the vehicle and remove the wheel blocks.
9. Connect the negative battery cable.

RELAY REPLACEMENT

1. Disconnect the negative battery cable from the battery.
2. If necessary, remove the power distribution box cover.
232
HOW TO USE THIS BOOK
Remove the starter motor (arrow) mounting bolts ...
RELAY REPLACEMENT