Ford Ranger Maintaince And Repair Manual page 1084

... then remove the handle by pulling it from the window crankshaft
7. If equipped with power accessories, use the notch at the lower end of the plate and pry the plate off.
Remove the plate from the trim panel and pull the wiring harness from behind the panel. Disconnect
the harness from the switches.
8. Remove any retaining screws uncovered by the removed trim pieces.
9. Using a flat wood spatula, insert it carefully behind the panel and slide it along to find the push−pins.
When you encounter a pin, pry the pin outward. Do this until all the pins are out. NEVER PULL ON
THE PANEL TO REMOVE THE PINS!
10. Lift slightly to disengage the panel from the flange at the top of the door.
REMOVAL & INSTALLATION
HOW TO USE THIS BOOK
... and remove the crank handle retaining screw ...
1107