Removal & Installation - Ford Ranger Maintaince And Repair Manual

REMOVAL & INSTALLATION
Bench Seat
1. On the right side, remove the seat track insulator.
2. Remove 4 seat track−to−floor retaining screws (2 each side) and lift the seat and track assembly from
vehicle.
3. To remove the tracks from the seat, place the seat upside−down on a clean bench.
4. Disconnect the track latch tie rod assembly from latch lever and hook in the center of the cushion
assembly.
5. Remove 4 track−to−seat cushion retaining screws (2 each side) and remove the tracks from the
cushion assembly.
To install:
6. Position the track to the cushion assembly. Install the 4 track−to−seat retaining screws and tighten.
7. Connect the track latch tie rod assembly to the latch lever and hook in center of cushion.
8. Position the seat and track assembly in the vehicle.
9. Install the 4 seat track−to−floor retaining screws and tighten to specification.
10. On the right side, install the seat track insulator.
Bucket and 60/40 Seats
1132
HOW TO USE THIS BOOK
Ranger bench seat
Click to enlarge
REMOVAL & INSTALLATION