Ford Ranger Maintaince And Repair Manual page 808

1. Remove the outer hub cover.
2. Remove the snap−ring from the end of the splined axle shaft.
3. Remove the axle shaft spacer(s).
Do not pry on the locking cam or thrust spacers during removal. Prying may damage the cam or spacers.
4. Pull the locking cam assembly and the two thrust spacers (behind cam assembly) from the wheel
bearing adjusting nut.
5. Installation is the reverse of the removal procedure. Make sure to install the two thrust spacers first.
Also, when pushing or pressing the locking cam into position, ensure that the key in the cam assembly
is aligned with the keyway of the front spindle.
Extreme care must be taken when aligning the locking cam key with the keyway on the front spindle to
prevent damage to the fixed cam.
820
HOW TO USE THIS BOOK
Exploded view of the locking cam assembly
Click to enlarge
WARNING
WARNING
REMOVAL & INSTALLATION