Dust Slinger/Boot Replacement; Double Cardan Type Front And Rear Driveshaft; Removal & Installation - Ford Ranger Maintaince And Repair Manual

DUST SLINGER/BOOT REPLACEMENT

1. Remove the boot clamp using cutter pliers and discard the clamp. Remove the boot from the stud
yoke.
2. Install a new dust slinger/boot on the stud yoke making certain the boot is seated in the groove in the
yoke.
3. Install a new clamp on the boot. Position the clamp tabs in the slots so each tab fits into a slot. Then,
crimp the clamp securely using a pair of clamp pliers T63P−9171−A or equivalent. Do not crimp to
the point where the clamp damage the boot.

Double Cardan Type Front and Rear Driveshaft

REMOVAL & INSTALLATION
1. Disconnect the negative battery cable.
2. Raise and support the vehicle safely.
DUST SLINGER/BOOT REPLACEMENT
HOW TO USE THIS BOOK
Dust slinger & boot
Click to enlarge
Rear driveshaft−single & double cardan type
Click to enlarge
803