REMOVAL & INSTALLATION
1.
Raise and support the front end on jackstands.
2.
Remove the wheels.
3.
Remove the caliper, rotor and hub.
4.
Using a 3−jawed puller, remove the ring from the hub. The ring cannot be reused; it must be replaced.
To install:
5.
Support the hub in a press so that the lug studs do not rest on the work surface.
6.
Position the newsensor ring on the hub. Using a cylindrical adapter 98mm ID X 106mm OD, press
the ring into place. The ring mustbe fully seated!
7.
The remainder of installation is the reverse of removal.
Rear Speed Sensor Ring
REMOVAL & INSTALLATION
The ring is located on the differential case inside the axle housing. Once it is pressed off the case it cannot be
reused. This job should be left to a qualified service technician as it requires the rear differential to be
disassembled.
Chilton® Automotive Information Systems. © 2004 Thomson Delmar Learning.
1068
HOW TO USE THIS BOOK
Front wheel sensor ring−4−wheel ABS
Click to enlarge
REMOVAL & INSTALLATION